User's Manual - Kitagawa Europe

ParameterMAC mini iH Series Parameter・Expansion Manual1.1.2.Setting steps 1 MODE (Push until PARAM is selected.)2 ENT (Make PRM110 in setting state.)3 1 or 9 9 9 (Input a settable code.)4 ENT (Set a SET PERMISSION code.)A:110 1PRM INPUT permissionAbove is the steps for PRM INPUT PERMISSION and the PARAM LED ofMODE flickers.In case of 2-axis spec., push aA/Ba and select the axis that sets theparameter before inputting the following data.5 aNa [PRM No.] aENTa (Specify the parameter set.)6 ENT [Set value] aENTa (Change to set value.)Similarly, change the parameter required for change.7 INPUT (Parameter setting register)A:003 33.33RAPID TRAVERSEParameter setting• As the parameter selection method of 5, the parameter can also beselected one by one with N+ (Next selection), N- (Formerselection).• When inputting the set value of 6, the current set value flickers bypushing ENT first. When pushing aENTa after inputting the setvalue, a newly set value lights.Precautions 1. When aINPUTa is not pushed after changing the parameter, the finalparameter is not set.When the mode is changed and power is turned OFF without pushingaINPUTa, the parameter set value returns to the value before changing.P1-2 KITAGAWA