User's Manual - Kitagawa Europe

AlarmsMAC mini iH Serieses Maintenance ManualErr. No.854Description of alarmOver-run alarmC a u s eInternal errorD e t a i l sC o u n t e r m e a s u r e s1. Receiving buffer is full. 1. Reset failure.855901Command receiving disable mode1. Neither AUTO nor SINGLE mode isselected when receiving a host commandto order an operation.EEPROM program area errorRemote control (RC) mode is wrong.1. Select AUTO or SINGLE mode when executingremote control.Program EDIT is wrong.1. Block copy is executed at the final block. 1. Block copy cannot be executed at the final block. Usean expansion channel if the number of blocks in thechannel is not enough.911930931940Parameter input error1. INPUT key is pushed regardless ofparameter CHANGE or UNCHANGE inPARAM mode when PRM110 is not 1,orPRM110 is not 999.Program channel number input error1. Selected the channel the block number ofwhich is 0.Program block number input error1. Selected a block number that does notexist.Program G-code input error1. Input a wrong value for program G code.2. G-code in the sending program throughcommunication is wrong.Remote control mode is wrong.2. Set PRM110 at 1 or 999 when changing the parameter.Selected the channel number that cannot be selected.1. The channel the parameter of which is 0 cannot beselected for PRM400PRM489.Selected the block number that cannot be selected.1. Block numbers higher than set value for PRM400PRM489 cannot be selected.The set value for Program G-code is wrong.1. Input an adequate value for G-code.2. Check the transfer content program and send normaldata.I1-18 KITAGAWA