User's Manual - Kitagawa Europe

ParameterMAC mini iH Series Parameter・Expansion ManualPRM046 [ NAME ] Panel ST Key Input Flag in AUTO Mode[ MESSAGE] ST KEY IN AUTO【DATA RANGE】 : 0,1Description Selects the VALID/INVALID of aST key input on the panel or pendant under AUTOmode.【 0 】 : Valid (In the start INPUT, aSTa key input on the panel or pendant andST of external INPUT are valid.)【 1 】 : Invalid (In the start INPUT in AUTO mode, only ST of external INPUTis valid.)PRM047 [ NAME ] WZERO Position Setting every Channel[ MESSAGE] SETUP WZERO POS【DATA RANGE】 : 0,1Description Sets the specification of WZERO position when the manual WZERO position is set or G92is executed.【 0 】 : Common WZERO position for all channels【 1 】 : Can set WZERO position every channel.The following shows each operation content on PRM47.Setting of manualWZERO positionORG + INPUTProgram G92 commandChange of CHPRM047=0Coordinate position stoppedcurrently is updated toWZERO position. However,parameter does not change.WZERO position of OPTPOS by Address A of G92 isupdated. However,parameter does not change.No changePRM047=1Current coordinate positionis updated to WZEROposition and parameter forchannel during selection isalso updated.WZERO position is updatedparameter for channel forselection is updated.Parameter for WZERO isread.Change ofPRM0470 → 1 No change1 → 0 No changePrecautions 1. When changing PRM047 to “1”⇒“0”, the WZERO position of channel duringselection in change becomes a common WZERO position.Concerned parameters PRM300~PRM389(WZERO setting position everychannel)P1-32 KITAGAWA