User's Manual - Kitagawa Europe

MAC mini iH Series Maintenance ManualAlarmsErr. No.804805808820826827851852853Description of alarmC a u s eNC channel number error1. NC program channel number is wrongwhen automatic operation is performed.NC block number error1. NC program block number is wrong,when automatic operation is performedNC command error1. G code that became failure becauseof the internal processing, isexecuted.RS232C Hardware alarm1. The top of the host command is notDC2.2. The end of the host command is notDC4.3. The message received in the hostconnection exceeds 256 characters.Flaming alarm1. Transfer speed of RS232C does notcorrespond to the controller.Parity alarm1. Parity bit of the transfer data for RS232Cdoes not correspond to the controller.Illegal command alarm1. Received a host command that does notcorrespond with RC.No command alarm1. Received STT, STA and STB commandwhen no program exists in CH99 at RCIllegal G-code, address alarm1. Addresses that do not correspond withG code (A,D,F,) exist.2. Received G code that does not exist atRC.3. Received an address J at RC.D e t a i l sC o u n t e r m e a s u r e sThe transfer program is inadequate.1. Check the channel number of the sending program andsend normal data.The transfer program is inadequate.1. Check the block number of the sending program andsend normal data.Program error.1. Reset the failure.Communication failure1,2. Transfer the control code of XON/XOFF at anormal state.3. Make a communication data consisting of 256characters or less.Communication failure1. Make the communication protocol corresponding to iton controller side.Communication failure1. Make the communication protocol corresponding to iton controller side.Transfer command of the remote control (RC) is wrong.1. Check the transfer command on the machine, and senda correct command.Transfer command of the remote control (RC) is wrong.1. Check the transfer command on the machine, and senda correct command.Received the remote control (RC) code incorrectly.13.Check the transfer command on the machine, and senda correct command.KITAGAWA I1-17