User's Manual - Kitagawa Europe

MAC mini iH Series Operation ManualProgram4.3. Program display methodThe program is displayed on the LCD by editing the mode.ThoughChannelandBlock are usually displayed, the display contents of AddressandDataare changed by the program contents.Since this is divided into two addresses (NEEDED/UNNEEDED) by G-code inside of program,unneeded address is not displayed.AxisChannelG-addressA-address1 Channel2 Block3 Axis name4 G-address5 A-address6 F-address7 D-address BlockF-addressJ-addressD-addressEDIT Screen Display on 2nd AxisDisplays the number of program channel currently selected.Displays the number of program block currently selected.Displays the axis No. currently selected.In case of exclusive control for 1-axis, /A/ is displayed usually.In case of the exclusive controller for 1-axis, the change key A/B can changethe key to /A/ or /B/ .For address G, prepared G-code command is displayed.When only address G is displayed, the data shows nil.Address A that shows the angle and time is displayed on the upper right stage.When only address A is displayed, the data shows nil.Address F that shows rotation speed is displayed on the right side of lower stageblock No.When only address F is displayed, the data shows nil.Address D that shows the dividing is displayed on the right side of lower stageaddress F.When only address D is displayed, the data shows nil.KITAGAWA O4-3