User's Manual - Kitagawa Europe

ParameterMAC mini iH Series Parameter・Expansion Manual【 1 】 : External WZRNPerforms WZRN by inputting ZRN in MANUAL mode.【 2 】 : G99 CHECK SIGNAL (Only PRM027=1: VALID)This parameter is used for receiving the CHECK SIGNAL toG99FIN OUTPUT of PRM02.When inputting ZRN for PRM028 time, G99FIN OUTPUT isOFF.For details of this item, see PRM028.Precautions 1. Since this function requires ZRN INPUT, only MAC mini iH series functionseffectively.Concerned parameters PRM027,PRM028PRM030 [ NAME ] SP Signal Function Spec.[ MESSAGE] SP/EXT SP FUNC SPEC【DATA RANGE】 : 0,1Description Selects the function when aSTOP key of panel or pendant and an external SP signal arereceived during operation (AUTO、SINGLE).【 0 】 : For SP INPUT, the table stops temporarily.In STATUS, “RUN”+“STOP” light.【 1 】 : For SP INPUT, STOP + Program RESET are performed.In STATUS, “RESET” lights.PRM031 [ NAME ] External MZRN Function[ MESSAGE] MZRN BY THE EXT ST【DATA RANGE】 : 0,1,2,3Description Sets whether MZRN is performed or not by the external start signal.【 0 】 : MZRN External Start INVALIDJust after power ON (STATUS: NOT READY), MZRN can beperformed by MZERO key operation on the panel or pendant, or anexternal ZRN mode.【 1 】 : MZRN External Start available Type 1The first External Start input signal, just after power turns on,implements MZRN. And then after Machine return to the origin, itautomatically switches to AUTO mode. Additionally, in this type ofMZRN, MANUAL mode still outputs the signals of both BLKFIN andZRNFIN.In case of 4 th and 5 th axes, both axes return to the origin at once.P1-26 KITAGAWA