User's Manual - Kitagawa Europe

MAC mini iH Series Operation ManualKey Switches & Display2.2.6.Programcommunication keysThese keys are used for communicating the program data to externalequipment.The following procedure is recommended for operating the program under theEDIT mode.! Channel key This key is used for selecting the channel.! CommunicationkeyThis key is used for inputting the program to theselected channel from the external equipment.This key is used for outputting the program ofselected channel to the external equipment.! CommunicationEDIT key# State display When the external INPUT or OUTPUT of program isselected, the external communication is started andthe message showing I/O and the block No. whilecommunicating are displayed on the screen. Whenthe communication is finished, the message of“END” is displayed. Cancels variously established modes and interruptsdata communication. 2.2.7.Parameter operation These keys are used for operating various parameters to control the circularkeystable.(For detailed parameters, see Clause 15 Parameters.)The following procedure is recommended to operate the table under thePARAM mode.! Numerical The numerical keyboard has ten-key and mark keys keyboardto input the number and set value of each parameterwith these keys. KITAGAWA O2-7