User's Manual - Kitagawa Europe

MAC mini iH Series Parameter・Expansion Manual Parameter1.2. Parameter list‣ Mark ◆ in remarks’ column shows that a set value cannot be changed.‣ For mark ★ in remarks’ column, it is necessary to turn OFF power in order to make a changed parametervalid.‣ In MAC mini iH2/iHT, when a standard set value differs per axis, the values of A-axis/B-axis are enteredto the standard set values. In case of MAC mini iH/iHF/iHP (1-axis spec.), A-axis is set.‣ The parameter that the parameter column is masked shows that it is common parameter in case of 2-axisspec.No.000002003004005006007008009010011013014015016017018020NameSTD Set-valueRemarSet unit Set rangeDisplayed Message A-axis B-axisksROM Version◆ROM VERMZRN DECEL. Speed0.70 min -1 0.03~1.00 Note2MZRN LOW FEEDRapid Traverse(Max. rotation speed)41.66 16.66 min -1 Note10.03~99.99RAPID TRAVERSENote2JOG HI Speed41.66 16.66 min -1 Note10.03~99.99HI JOG FEEDNote2JOG HI Speed1.00 min -1 0.03~99.99 Note2LO JOG FEEDStep Feed AmountSTEP FEED AMOUNT0.001 deg 0.000~10.000MZRN Shift Amount-360.000~0.000 degMZRN SHIFT AMOUNT360.000★MZRN Feed41.66 min -1 Note10.00~99.99MZRN FEEDNote2Position Deviation Check Setting Time0.30 SEC 0.00~1.00POS-DEV CHECK TIMERPosition Deviation Check Setting _Amount0.100 deg 0.000~16.000POS-DEV CHECK AMOUNTGear Ratio 1/X★72 180 0,36,45~999GEAR RATIO 1/XNote1Motor Rev. direction Flag★0 0,1MOTOR DIRECTIONNote1Override Step AmountMOTOR DIRECTION5 % 0~100Deviation Check Amount in Clamp0.020 deg 0.000~16.000POS-DEV CHECK CLAMPMZRN DirectionMZRN DIRECTION0 0,1MZRN・WZRN in Short Cut Direction0 1 0,1,2ZRN SHORT CUT DIROptional Angle Assignment in Short CutReturn Direction0.000 deg 0.000~359.999ZRN DIR OPT POSBLKFIN Output Flag in G08, G090 0,1BLKFIN FLAG (G08)KITAGAWA P1-3