User's Manual - Kitagawa Europe

AlarmsMAC mini iH Serieses Maintenance ManualErr. No.031032Description of alarmOver travelOver travelC a u s e1. Over travel is detected.The machine is positioned at Though machine is not in OT position, whenalarm occurs, the following problems areconsidered.2. The detect switch for over travel is out oforder.3. The cable for over travel is incorrect.4. Parameter setting is inadequate.D e t a i l sC o u n t e r m e a s u r e sHard limit + side is detected.Hard limit - side is detected.1-1. Release the over travel with the following procedurewhen an alarm is detected during table rotation. After reset, set mode to MANUAL. In case of Err.031, push DEL key to shift table tothe location where over travel is released. In case ofErr.032, use INS key for the same procedure. In case of Err.031032, in order to avoid collision,single use of DEL or INS key can not rotatetable to the direction of the collision.1-2. When shifting table in direction other than escapedirection even if alarm is detected, release OTaccording to the following procedure. After resetting and set mode to MANUAL. In case of Err.031, push OVR + DEL keys torotate the table to the location where over travel isreleased. In case of Err.032, use OVR + INSakeys for the same procedure. Because the table is rotated forcedly by pushingOVR key, take extreme care to release OT.For safety reasons, rotation speed is set at 0.5min -1in the collision direction.2. Replace the over travel detecting switch.3. Replace the cable.4. Recheck and change PRM206.080082EEPROM Writing error1. An inconsistency is identified bychecking after EEPROM WRITE.EEPROM clear error1. An inconsistency identified by checkingafter the content of EEPROM is erased.An error occurs on EEPROM check in power ON.1-1. Reset or turn ON power again.1-2. Clear RAM if it is not released by power recharge.An error occurs during an EEPROM check in power ON.1-1. Reset or turn ON power again.1-2. Clear RAM if it is not released by power recharge.I1-12 KITAGAWA