User's Manual - Kitagawa Europe

MAC mini iH Series Operation ManualProgram4.5.15. BLKFIN NON-OUTPUTBLKFIN NON-OUTPUT command (G97) does not output BLKFIN on the usual programexecution.When operating the circular table by interlocking with the machine, this command is not usedusually. This code is used for operating the circular table independently without operatingenvironment equipment by BLKFIN output.Precautions Since the G97 does not output the BLKFIN for ST input from external equipment, when theexternal start signal is turned OFF at FLKFIN OFF, the external equipment waits the FINsignal, thus stopping as is.Program FormatG97 A F D JBoldface and italic type characters can beabbreviated.DescriptionG97 BLKFIN NON-OUTPUT commandA Rotation angle Setting unit degSetting range 999.999In incremental0 359.999In absoluteF Rotation speed Setting unit 0.01min -1Setting range 03 9999D Equal dividing number Setting range 0 999J Program jump Setting range -1 999destinationJ-1 Subprogram return commandAddresses A, F, D and J are the same as “Non-G code Type (Standard)”.KITAGAWA O4-39