User's Manual - Kitagawa Europe

Program OperationMAC mini iH Series Operation Manual17) ・ N+Calls N002 block that adds 1 to N001.18) A/B Push 1A/B to display A-axis.ENT19) 7 GENT20) 2 L 3 N-ENT When inputting 1J , the under bar is21) 9 Jdisplayed under the character 『J』.After inputting 1ENT , Address J flickersand the value can be set.22) 0 CHENT 『0』 is inputted in Address J and itlights.The program block is stored.23) A/B Push 1A/B to display B-axis.24)7 GENT25) 2 L 3 N-ENT26) INPUT Stores the block of program.When『/A/』flickers during program EDIT, it shows that the program ischanged.While flickering of『/A/』, the changed program is not stored into thememory. The timing that the program is stored is when the followingoperations are performed:• When block change is operated by 1N+1,1N-1.• When block No. is called by 1N1,1*1,1ENT .• When forcedly written by 1INPUT1.• When the mode is changed by 1MODE1.Therefore, the data is stored into memory every block shift during programEDIT.However, the power is turned OFF while flickering of 『/A/』 or ,1RESET is pushed, the program returns to the state before changing.O5-8 KITAGAWA