User's Manual - Kitagawa Europe

RAM ClearMAC mini iH Series Maintenance Manual2.3. All data clear of parameterWhen this operation is performed, the parameter data stored into the memory in the controller isinitially set. POWER ON! The all clear mode (CL-2) of program is entered in power ON.Parameter Clear Screen ! Number “1” (Standard) is displayed on the right side of CL-2display by inputtingENTa. [] ! Selects that the parameter clear is performed at which content.1 General parameter of MAC mini I series2 General parameter of MAC mini iH series3 Servo parameterThe parameter clear is started and the value during clear is countedon the right side. When CL-2 END is displayed, the clearmode is finished.Even if CAN is pushed during parameter clear, the parameterclear mode cannot be interrupted. Starting screen ! The same screen as a starting state in usual power ON is displayed tostart the screen.Because parameter clear is performed, Err.400 MZERO POSUN-SETUP and Err.930 ENC BATTERY ALARM occurcertainly.I2-4 KITAGAWA