User's Manual - Kitagawa Europe

MAC mini iH Series Operation ManualDiagnostics7.2. Command work coordinate display The angle commanded by the program is displayed on the coordinate system on the basis ofWZRN position 0.000.7.2.1.Command workcoordinate screenChannel No.Command angle Block No.Command work coordinate In case of 2-axis spec., the content of A-axis is displayed on upper stageand that of B-axis on lower stage. The block No. displayed becomes an execution block during operationand it becomes a next execution block during stop.7.3. Command machine coordinate display The angle commanded by the program is displayed on the coordinate system on the basis ofWZRN position 0.000.7.3.1.Command machinecoordinate screenChannel No.Command angleBlock No. Command machine coordinate display In case of 2-axis spec., the content of A-axis is displayed on upper stageand that of B-axis on lower stage. The block No. displayed becomes an execution block during operationand it becomes a next execution block during stop.KITAGAWA O7-3