User's Manual - Kitagawa Europe

ProgramMAC mini iH Series Operation Manual4.5. G-code functionsThe controller provides the preparatory function (G-code) to allow the machine to make thedetermined operation. The preparatory function command is indicated with the value continued tothe address G.The G-code is divided into two types.TypeContentsOne shot G-codeG-code effective only block specifiedModal G-codeG-code effective continuously until a reciprocity G-code iscommanded.! Any G codes marked with are in the modal information column of G-code list aremodal type. The G code marked with becomes effective continuously until the G-codemarked with is commanded. Similarly, the G code marked with becomes effectivecontinuously until the G-code marked with is commanded.! G codes except marks are one shot type.! Model information is returned to the initial setting mode which becomes the state markedwith of the modal information list, when MAC-controller is operated by turning thepower off, reset, mode change, channel change by the panel, and external channelchange(PRM112=1).! When any G-code except the G-code in the list is commanded, the alarm of Err940PROG G ERROR (Program G-code error) occurs.Precautions)# Even if the program is executed at 2-axis spec., modes do not synchronize. The programis executed the program content set every axis.# When the block having programs for two axes is executed, BLKFIN is outputted afterprograms of both axes are completed.O4-6 KITAGAWA