User's Manual - Kitagawa Europe

ProgramMAC mini iH Series Operation Manual8 J-address9 Other axis markAddress J that shows jump is displayed on the lower right stage.When only address J is displayed, the data shows nil.In 2-axis spec., when the program exists to the axis that is different as the screendisplay axis, this mark is displayed. In 1-axis spec., this mark is not displayed.P-addressE-addressG27 Screen DisplayL-address10 P-address11 E-address12 L-addressAddress P that shows the start block No., of repeating function is displayed to theright side of G27 on the right stage only when G27 is commanded.When only address P is displayed, the data shows nil. At this time, when theprogram is stored, the alarm of Err962 EDIT ILLEGAL G occurs.Address E that shows the end block No., of repeating function is displayed to theupper right side only when G27 is commanded.When only address E is displayed, the data shows nil. At this time, when theprogram is stored, the alarm of Err962 EDIT ILLEGAL G occurs.Address L that is optionally outputted in the repeating frequency of its functionor interlocking function (G21) is displayed on the center of lower stage.The address L is displayed only when G21 and G27 are commanded.When only address L is displayed, the data shows nil. When the program isstored with G27 commanded, the alarm of Err962 EDIT ILLEGAL G occurs.O4-4 KITAGAWA