User's Manual - Kitagawa Europe

ProgramMAC mini iH Series Operation Manual4.5.12. REPEATINGThis repeating command (G27) repeats the program by specified times at place between specifiedblocks (Repeating start block Repeating end block).G27 command can be nested by maximum 8 times (G27 commanded between Repeating start blockRepeating end block specified by G27).Program FormatG27 P E L JBoldface and italic type characters can beabbreviated.DescriptionG27 Repeating command PE Repeating programStart block No. Repeating programEnd block No.Setting range 1 999Setting range 1 999L Repeating frequency Setting range 0 999J Program jumpSetting range -1 999destinationJ-1 Subprogram return commandAddress P (START Block No.)# Address P is an essential setting address.When there is no P-setting, the alarm of Err962 EDIT ILLEGAL GIllegal G-code occurs.# When the set value of Address E is more than that of Address P, thealarm of Err962 EDIT ILLEGAL G occurs.Address E (End Block No.)# Address E is an essential set-address.When there is no E-setting, the alarm of Err962 EDIT ILLEGAL GIllegal G-code occurs.# When the set value of Address E is less than that of Address P, also, thealarm of Err962 EDIT ILLEGAL G occurs.Address L (Repeating Frequency)# Address L is an essential set-address.When there is no L-setting, the alarm of Err962 EDIT ILLEGAL GIllegal G-code occurs.In case of L0, it is processed as l1.Addresses J is the same as “Non-G code Type (Standard)”.O4-32 KITAGAWA