User's Manual - Kitagawa Europe

MAC mini iH Series Operation ManualProgram4.5.4. CONT. BUFFERThe blocks from a continuous buffer START COMMAND (G08) to END COMMAND (G09) areoperated continuously.In the block during continuous buffer execution, BLKFIN/G99FIN are not outputted.Since G08 and G09 are modal commands, unless opposite commandG08$G09is commanded, theyare continued continuously. Program Format Boldface and italic type characters can beabbreviated.G08 Continuous buffer startcommandG09 Continuous buffer end commandA Rotation angle Setting unit degSetting range 999.999In incremental0 359.999In absoluteF Rotation speed Setting unit 0.01min -1Setting range 03 9999D Equal dividing number Setting range 0 999J Program jump Setting range -1 999destinationJ-1 Subprogram return commandDescriptionPrecautions on 2-axis spec.Addresses A, F, D and J are the same as “Non-G code Type (Standard)”.When commanding G08 and G09, 2-axis specifications are limited to the followingitems.➢ When commanding G08, both axes execute buffer continuously.➢ Since the program in command into the buffer mode are moved in next blockafter both 2 axes are operated, the axis that operation time is short stops andwaits until other axis operation finishes.➢ Though G8 may command either A-axis or B-axis, G09 is commanded to theaxis that G08 is commanded.When G09 is commanded to another axis, “Err230 ILLEGAL G09” occurs.➢ For the block that G8 or G9 exists in each axis, G code cannot beprogrammed to another axis.When G code is commanded, “Err962 EDIT ELLIAGAL G” occurs.KITAGAWA O4-15