User's Manual - Kitagawa Europe

MAC mini iH Series Parameter・Expansion Manual ParameterPRM244 [ NAME ] RS232C Stop Bit[ MESSAGE] RS232C STOP BIT【DATA RANGE】 : 0,1DescriptionSets the stop bit of communication protocol.【 0 】 : 2 bit【 1 】 : 1 bitPrecautions 1. To make this parameter valid, it is necessary to turn OFF the power once.Concerned parameters PRM240,PRM242,PRM243PRM245 [ NAME ] Servo Parameter Check Function in Power ON[ MESSAGE] SERVO PRM CHECK FUNC【DATA RANGE】 : 0,1,2DescriptionPrecautionsSelects the specifications of servo parameter to be checked when the power for thecontroller is turned ON.【 0 】 : Communication YES/Parameter check YESChecks that the servo parameter content stored in previous power OFFis correct in power ON.When there is incorrect content by the servo parameter check, theparameter No. is communicated on the start screen in power ON and itis automatically corrected into the stored servo parameter.【 1 】 : Communication NO/Parameter check YESChecks that the servo parameter content stored in previous power OFFis correct in power ON.Even if there is incorrect content by the servo parameter check, theparameter No. is not communicated and it is automatically correctedinto the stored servo parameter.【 2 】 : Parameter check NOThe servo parameter in power ON is not checked.Even if the parameter does not correspond to the stored servoparameter, it is not corrected.1. To make this parameter valid, it is necessary to turn OFF the power once.2. This parameter functions from power OFF to next power ON. Therefore, theservo parameter can be changed during power ON.KITAGAWA P1-41