User's Manual - Kitagawa Europe

ParameterMAC mini iH Series Parameter・Expansion ManualPRM023 [ NAME ] Alarm Scan Cycle of Unclamp Signal[ MESSAGE] ALARM SCAN UNCLUMP【DATA UNIT】 : sec【DATA RANGE】 : 0.00~10.00Description The unclamp signal is monitored usually to set the detecting times for incorrect signalssuch as unclamp signal OFF during operation, unclamp signal ON during table clamp, etc.When the unclamp check signal fails over this set time, the alarm of 『 ERR016 BRAKEFAILURE 』 occurs.REV.CLAMP OUTPUT(EXE UCL)IN ABNRMLIN NRMLUNCLAMP CHECK SIG(BK.UC)CHECKIN ABNRMLCHECKWhen time is more than set value PRM023, Err016 occurs.Precautions 1. When PRM032=1(Clamp unused) or PRM038=1, this mode becomes invalid.2. In case of PRM023=0, the table is monitored by the unclamp check signal for onlywhen operation START/STOP.Concerned parameters PRM032, PRM038PRM024 [ NAME ] Alarm Scan Cycle of Clamp Signal[ MESSAGE] ALARM SCAN CLAMP【DATA UNIT】 : sec【DATA RANGE】 : 0.00~10.00Description The clamp signal is monitored usually to set the detecting times for incorrect signals suchas clamp signal ON during operation, clamp signal OFF during table clamp, etc.When the clamp check signal fails over this set time, the alarm of 『 ERR016 BRAKEFAILURE 』 occurs.REV.CLAMP OUTPUT(EXE UCL)IN ABNRMLIN ABNRMLUNCLAMP CHECK SIG(BK.C)CHECKWhen time is more than set value PRM024, Err016occurs.CHECKIN NRMLPrecautions 1. When PRM032=1 (Clamp unused) or PRM038=0, this mode becomes invalid.2. In case of PRM024=0, the table is monitored by the unclamp check signal for onlywhen operation START/STOP.Concerned parameter PRM038P1-22 KITAGAWA