User's Manual - Kitagawa Europe

MAC mini iH Series Parameter・Expansion Manual ParameterPRM100 [ NAME ] Software Limit Specification[ MESSAGE] S/W LIMIT SPEC【DATA RANGE】 : 0,1,2Description Selects the specification of software to limit a machine operation range by the software.【 0 】 : Invalid【 1 】 : Check during operationWhen the position coordinate during operation reaches a software limitMIN (PRM101) and software limit MAX (PRM103) on the machinecoordinate system, an alarm occurs.【 2 】 : Check before operationThe shifting destination coordinate is checked before operation in theprogram operation. When the coordinate reaches a software limit MIN(PRM101) and software limit MAX (PRM103) on the machinecoordinate system, an alarm occurs.During manual feed, this mode is the same as check during operation(PRM100=1).Concerned parameters PRM101,PRM103PRM101 [ NAME ] Software Limit MIN[ MESSAGE] S/W LIMIT OF MIN【DATA UNIT】 : deg【DATA RANGE】 : 0.000~359.999Description Sets the machine coordinate position to limit a minus side when the software limit is valid(PRM100=1 or 2).Concerned parameters PRM100,PRM103PRM103 [ NAME ] Software Limit MAX[ MESSAGE] S/W LIMIT OF MAX【DATA UNIT】 :deg【DATA RANGE】 : 0.000~359.999Description Sets the machine coordinate position to limit a plus side when the software limit is valid(PRM100=1 or 2).Concerned parameters PRM100,PRM101KITAGAWA P1-33