User's Manual - Kitagawa Europe

MAC mini iH Series Operation ManualKey Switches & Display2.2. Key operation2.2.1.Mode operation keyTo perform each operation, it is necessary to select each operation mode.! Mode change keyChanges the mode in order. 2.2.2.Since MAC mini iH2/iHT have two control axes, it is necessary to change theAxis change keyaxis when each mode is set.Changes the display of A-axis/B-axis as often as theswitch is pushed. 2.2.3.Manual operation keys This key operates and sets the circular table connected to the controller underthe manual operation mode.! JOG feed(low speed)! Step feed! JOG feed(high speed) ENABLE switch ENABLE switch ENABLE switch1-shot pushed ENABLE switch1-shot pushed ENABLE switch ENABLE switchOperates the table in CW (Clockwise direction). Thetable rotates continuously at speed set to PRM005with the key still pushed.Operates the table in CCW (Counterclockwisedirection). The table rotates continuously at speed setto PRM005 with the key still pushed.Pushing this key 1-shot feeds at a step in CW(Clockwise direction). The feedrate is the angle set toPRM006.Pushing this key 1-shot feeds at a step in CCW(Counterclockwise direction). The feedrate is theangle set to PRM006.Operates the table at rapid traverse in CW (Clockwisedirection)The table rotates at speed set to PRM004.Operates the table at rapid traverse in CCW(Counterclockwise direction)The table rotates at speed set to PRM004.KITAGAWA O2-3