User's Manual - Kitagawa Europe

MAC mini iH Series Operation ManualOperation6.5. Manual pulse generatorOptionThe manual pulse generator can be used by the MANUAL mode.The following explains the operating steps of manual pulse generator.6.5.1.Conf. display of Display to check that the manual pulse generator selects the axis as is.manual pulsegenerator Selected to A-axis ! LED on A-axis of 1A/B1 flickers.Selected to B-axis! LED on B-axis of 1A/B1 flickers.Axis set to OFF.! LED on A-axis or B-axis (selected side) of1A/B1 lights.6.5.2.Shifted by manualpulse generatorShift the axis with the manual pulse generator.Axis selectionShift factor selectionDial turned in CWDial turned in CCW.! Push 1MODE1 and selects MANUAL .! Select the axis to be shifted with the manualpulse generator.In case of 1-axis spec., A-axis is selected.In case of 2-axis spec., A-axis or B-axis isselected.! Select the scale factor of feed with the manualpulse generator as follows:When shifting at 0.001unit, 1 isselected, at 0.01 unit, 10 is selectedand at t 0.1 unit, 100 is selected.! Selected axis is shifted in directionaccording to the scale factor.! Selected axis is shifted in directionaccording to the scale factor.Precautions " A / B axes of 2-axis spec., are set by PRM117. The axis set as PRM117=1is A-axis and the axis set as PRM117=2 is B-axis" When operating the rotary table with the manual pulse generator, though thetable may rotate in an improper motion, there is no problem.KITAGAWA O6-7