User's Manual - Kitagawa Europe

I/O SignalsMAC mini iH Series Connection Manual8.1.2.6.CHSEL0,1,2,3(M-signal type)signals! Contents When CHSEL0 and INCOM are short-circuited, channel No. 00 isselected as ZERO signal. When CHSEL1 and INCOM are short-circuited, channel No. is addedone by one as PLUS1 signal. When CHSEL2 and INCOM are short-circuited, channel Nos. areadded ten by ten as PLUS10 signal. When CHSEL3 and INCOM are short-circuited, channel Nos. arereduced ten by ten as PLUS10 signal. Channels can be increased to max. channels without exceeding its setvalue. (Max. value is determined to PRM390PRM400PRM489.! Conditions1. This mode is valid for only when PRM033=1 and also PRM112=1.2. When STATUS is STOP or RESET state under AUTO mode, M-signalcan be changed.3. While any signal is being inputted, other signals cannot be inputted.4. ZEROPLUS1PLUS10MINUS10 signals are to be inputtedcontinuously at 100msec or more.5. ZERO signal and PLUS signal are continuously inputted, the intervalsof 100msec or more are to be provided.6. The selection of channel inputted during BLKFIN or G99FIN output isto be invalid.8.1.2.7.CHSET signal ! Contents When CHSET and INCOM are short-circuited during the binarymode, the channel can be changed.! Conditions1. This mode is valid for only when PRM033=0 and also PRM112=1.2. When the channel setting mode is set to AUTO, STATUS is to beSTOP or RESET state.3. CHSET is to be continuously inputted for 500msec or more.4. The selection of channel inputted during BLKFIN or G99FIN output isto be invalid.C8-6 KITAGAWA