User's Manual - Kitagawa Europe

I/O Signals8.1.2.1.ST SignalMAC mini iH Series Connection Manual! Contents The start (ST) signal is inputted by short-circuiting ST and IN COM. The program of selected channel is executed under AUTO or SINGLEmode. When the ST signal is inputted with the controller stoppedtemporarily, the program is restarted.! Conditions1. The ST signal is to be INVALID unless an input time is continuous100msec or more. INVALID START SIG(ST)>100msec 100msec or less2. The AUTO or SINGLE mode is to be possible to start the program.3. The program is not to be executed. (STATUS is not to be RUN.However, it is except in case of RUN+STOP.)4. Any alarm is not to be occurred. (STATUS is not to be ALARM.)5. Other START signals (Panel) are not to be INPUT state.6. Temporary stop (SP) is to be ON.BLKFIN is not to be outputted, and after BLKFIN is OFF, 100msec ormore is to be passed.DURING PRG EXEST INPUT INVALIDAREASTART SIG(ST)START SIG(ST)ONE SHOT TYPEBLKFIN SIG(BLKFIN)ST INPUT VALID(>100msec)100msec 8.1.2.2SP signal ! Content The STOP signal is inputted by opening SP and IN COM. The program operation is stopped temporarily.! Conditions1. To be during AUTO RUN. (STATUS is to be RUN.)2. When SP signal is turned OFF during ST signal ON, the programoperation is stopped immediately.3. Even if ST signal is turned ON during SP signal OFF, AUTO RUN isnot to be started.C8-4 KITAGAWA