Bid Package 08 North Well Field - Garney Construction

E. Coordinate with architectural reflected ceiling plans the exact location and dimensioning of
items which occur within hung ceilings. Request clarification from the Engineer prior to
proceeding with fabrication or installation if a conflict exists.
F. Schedule construction activities in sequence required to obtain best results where
installation of one part of the Work is dependent on installation of other components, either
before or after its own installation.
G. Make adequate provisions to accommodate items scheduled for later installation, including:
1. Accepted alternates,
2. Installation of products purchased with allowances,
3. Work by others,
4. Owner-supplied, BIDDER-installed items.
H. Sequence, coordinate, and integrate the various elements of mechanical, electrical, and
other systems, materials, and equipment if applicable. Comply with the following
requirements:
1. Coordinate mechanical and electrical systems, equipment, and materials installation
with other building components.
2. Verify all dimensions by field measurements.
3. Arrange for chases, slots, and openings in other building components during progress of
construction.
4. Coordinate the installation of required supporting devices and sleeves to be set in castin-place
concrete and other structural components, as they are constructed.
5. Install systems, materials, and equipment as permitted by codes to provide the
maximum headroom possible where mounting heights are not detailed or dimensioned.
6. Coordinate the connection of systems with exterior underground and overhead utilities
and services. Comply with the requirements of governing regulations, franchised
service companies, and controlling agencies. Provide required connection for each
service.
7. Install systems, materials, and equipment to conform with approved submittal data,
including coordination drawings, to the greatest extent possible. Conform to
arrangements indicated by the Contract Documents, recognizing that portions of the
Work are shown only in diagrammatic form. Adjust routing of piping, ductwork, utilities,
and location of equipment as needed to resolve spatial conflicts between the various
trades. Document changes in the indicated routings on the Record Drawings.
8. Install systems, materials, and equipment level and plumb, parallel and perpendicular to
other building systems and components.
9. Install systems, materials, and equipment to facilitate servicing, maintenance, and repair
or replacement of components. As much as practical, connect for ease of disconnecting,
with minimum of interference with other installations. Extend grease fittings to
accessible locations.
10. Install access panel or doors where units are concealed behind finished surfaces.
11. Install systems, materials, and equipment giving right-of-way priority to systems
required to be installed at a specified slope.
1.08 BIDDER'S USE OF SITE
A. Limit the use of Site for Work and storage to those areas designated on the Drawings or
approved by the Engineer. Coordinate the use of the premises with the CMAR/Engineer.
Project Management and Coordination – Bid Package #8 01 31 00-3
Colorado River Municipal Water District
Ward County Water Supply Expansion Project – North Well Field
5/24/2012