Bid Package 08 North Well Field - Garney Construction

B. Use test equipment and instruments to simulate inputs and read outputs suitable for
purpose intended and rated to an accuracy of at least five times greater than the required
accuracy of device being calibrated. Such test equipment shall have accuracies traceable to
the National Bureau of Standards as applicable.
2.04 SPECIAL PROJECT REQUIREMENTS
A. As a part of this Contract, the instrumentation systems CONTRACTOR shall coordinate with
the Owner and with all the sub-systems suppliers and manufacturers, during bidding,
construction, testing, installation and start-up phases of the project. The coordination is to
assure that the instruments and sub-systems are in compliance with the Contract
Documents and that the necessary tie-ins and interface signals with the existing system are
provided as specified or required.
B. The instrumentation system CONTRACTOR shall provide the OWNER's staff with all required
training and operating procedures, at no extra cost to the OWNER, in addition to the SCADA
training specified in Section 40 90 02, “Supervisory Control and Data Acquisition (SCADA)
System”. The training schedule shall be coordinated with the OWNER's Representative.
Training shall include operating, testing, calibration and programming of the system, and
simple troubleshooting of the system. The training shall include manuals which are
specifically written for the system provided as described in Division 1 - General
Requirements of these Specifications.
C. The calibration, testing, and start-up of all the instruments whether existing or provided
new, shall be done by the manufacturer's field technician/ENGINEER in the presence of the
OWNER. The CONTRACTOR shall provide a list of all manufacturers whose technicians will
perform this work. The CONTRACTOR shall also provide a certified calibration report stating
that each instrument shown or specified in the Contract Documents has been installed,
tested and calibrated per manufacturer's recommendations and per these Contract
Documents.
D. Follow-up Services: After the acceptance of the system, the CONTRACTOR shall make two
(2) trips to the project site for calibration and adjustment of all the instruments and devices,
including the SCADA system. The first trip shall be three months after acceptance of the
complete system, and thereafter every three months for a total of four trips. These trips
are in addition to all warranty items, and shall be at no extra cost to the OWNER. The
CONTRACTOR shall provide the services of a trained technician for each trip with
appropriate calibration and testing instruments. All defects shall be immediately remedied.
The trips shall be coordinated with the OWNER.
Instrumentation and Control for Process Systems 40 90 00-7
CMD11269 – Ward County Transmission System Expansion – Contract C – Above Slab TPS, OPS, and WPS