Bid Package 08 North Well Field - Garney Construction

Colorado River Municipal Water District
Raw Water Supply Well Sites
Ward County North Well Field
40 90 02.01
INSTALLATION OF PRE-PURCHASED SCADA EQUIPMENT
PART 1 GENERAL
1.1 WORK INCLUDED
A. The Contractor shall furnish all labor, tools, equipment and machinery necessary to
receive, inspect, unload, and install completely in proper operating condition, the
equipment pre-purchased by the Owner and assigned to the Contractor for installation.
Upon acceptance of the equipment, Contractor accepts all responsibility for its condition
and proper operation.
B. The Contractor shall also furnish all incidental items not supplied with the equipment that
may be required for complete installation, such as concrete pad, bolts, wiring, conduit,
grounding, and other appurtenances as necessary. The Contractor shall refer to Appendix
B for the Antenna Tower concrete base requirements.
C. The equipment pre-purchased by the Owner consists, in general, of the following items
for each of the 21 well sites:
1. RTU
2. Antenna Tower
3. Radio Antenna
D. General details of the equipment are provided herein. Technical Specifications for the
pre-selection or pre-purchase of Goods and Special Services are included in Appendix B.
1.2 QUALITY ASSURANCE
A. Inspect the condition of all equipment accepted for installation and promptly advise the
Owner in writing as to any defects or damage that may have occurred during shipment.
B. Provide the services of the Seller’s representative to assist in installation of the equipment
in accordance with the specifications included in appendices and Section 01 70 00
“Execution and Closeout Requirements.” Provide an equipment installation report as
required by Section 01 70 00 “Execution and Closeout Requirements.”
C. The service of the SCADA System Supplier’s representative is available to assist in
installation and start-up of the equipment in accordance with the specifications included
in Appendix B. Contractor shall schedule and request the representative to be available
when needed, to assist and instruct in the proper installation and adjustment of the
equipment. All work and adjustments shall be done in accordance with the SCADA
System Supplier’s recommendations and instructions of their representative.
May 18, 2012
Installation of Pre-Purchased SCADA Equipment
Revision 0 40 90 02.01-1