Bid Package 08 North Well Field - Garney Construction

4. Electrical and interconnection diagrams shall show all terminations of equipment,
complete with conduit, cable, and equipment designations, and shall include terminal
identification information.
5. Include size of all conduits, pipe, cables, and conductors.
6. Physical arrangement drawings shall include operating and servicing clearance
requirements, cooling requirements, electrical power requirements, and cabling
information.
7. Logic drawer drawings shall show used space and expansion space.
8. Show appropriate tag numbers on all product data.
9. Software specifications for all software provided in addition to existing standard
software.
a. Include fully annotated source listings, input-output requirements, memory
requirements, timing and sequencing requirements, flow chart showing functions
performed, operating sequences and decision points, required system
configuration, list of known or anticipated limitations of software modules, list of
malfunction procedures to be followed for recovering from operator error or other
malfunction, and description of how each module interfaces with calling and called
programs.
b. Provide proposed screen layouts showing modifications to existing screens, and
new screens: Show all displays, inputs, outputs, recorders, alarms and indications
along with the associated signal tag number. OWNER shall review and approve
screen layouts.
B. TECHNICAL MANUALS:
2.00 PRODUCTS
1. Supply six (6) sets of technical manuals with software specifications to OWNER's
Representative no later than the equipment shipment date. Each set shall be bound in
a standard size, three-ring, loose-leaf, vinyl plastic, hard-cover binder suitable for
bookshelf storage. Binder ring size shall not exceed 2.5 inches.
2. Each set of technical manuals shall include a general and detailed description, a theory
of operation description, detailed schematic drawings, specifications, and installation,
connection, calibration, operating, troubleshooting, preventive maintenance, and
overhaul instructions in complete detail with a clear and specific description of the
steps the operators must take to perform each of the tasks and modes of operating
specified. These manuals shall provide the OWNER with comprehensive information on
all systems and components to enable operation, service, maintenance and repair.
Exploded or other detailed views of all instruments, assemblies, and accessory
components shall be included together with complete parts lists and ordering
instructions. These manuals are in addition to all applicable requirements of Division 01
- General Requirements.
2.01 INFORMATION ON DRAWINGS
A. The following information is indicated on the drawings:
1. Loop diagram on flow sheet for each control loop. Diagrams are schematic in nature
and intended only as a guide to work to be performed.
Instrumentation and Control for Process Systems 40 90 00-5
CMD11269 – Ward County Transmission System Expansion – Contract C – Above Slab TPS, OPS, and WPS