Bid Package 08 North Well Field - Garney Construction

maintaining and supervising of safety precautions and
programs.
6.15 Hazard Communication Programs
A. CONTRACTOR shall be responsible for coordinating
any exchange of material safety data sheets or other hazard
communication information required to be made available to
or exchanged between or among employers at the Site in
accordance with Laws or Regulations.
6.16 Emergencies
A. In emergencies affecting the safety or protection of
persons or the Work or property at the Site or adjacent
thereto, CONTRACTOR is obligated to act to prevent
threatened damage, injury, or loss. CONTRACTOR shall
give ENGINEER prompt written notice if CONTRACTOR
believes that any significant changes in the Work or
variations from the Contract Documents have been caused
thereby or are required as a result thereof. If ENGINEER
determines that a change in the Contract Documents is
required because of the action taken by CONTRACTOR in
response to such an emergency, a Work Change Directive or
Change Order will be issued.
6.17 Shop Drawings and Samples
A. CONTRACTOR shall submit Shop Drawings to
ENGINEER for review and approval in accordance with the
acceptable schedule of Shop Drawings and Sample
submittals. All submittals will be identified as ENGINEER
may require and in the number of copies specified in the
General Requirements. The data shown on the Shop
Drawings will be complete with respect to quantities, dimensions,
specified performance and design criteria, materials,
and similar data to show ENGINEER the services, materials,
and equipment CONTRACTOR proposes to provide and to
enable ENGINEER to review the information for the limited
purposes required by paragraph 6.17.E.
B. CONTRACTOR shall also submit Samples to
ENGINEER for review and approval in accordance with the
acceptable schedule of Shop Drawings and Sample
submittals. Each Sample will be identified clearly as to
material, Supplier, pertinent data such as catalog numbers,
and the use for which intended and otherwise as ENGINEER
may require to enable ENGINEER to review the submittal for
the limited purposes required by paragraph 6.17.E. The
numbers of each Sample to be submitted will be as specified
in the Specifications.
C. Where a Shop Drawing or Sample is required by the
Contract Documents or the schedule of Shop Drawings and
Sample submittals acceptable to ENGINEER as required by
paragraph 2.07, any related Work performed prior to
ENGINEER’s review and approval of the pertinent submittal
will be at the sole expense and responsibility of
CONTRACTOR.
D. Submittal Procedures
1. Before submitting each Shop Drawing or Sample,
CONTRACTOR shall have determined and verified:
a. all field measurements, quantities, dimensions,
specified performance criteria, installation
requirements, materials, catalog numbers, and similar
information with respect thereto;
b. all materials with respect to intended use,
fabrication, shipping, handling, storage, assembly,
and installation pertaining to the performance of the
Work;
c. all information relative to means, methods,
techniques, sequences, and procedures of construction
and safety precautions and programs incident thereto;
and
d. CONTRACTOR shall also have reviewed
and coordinated each Shop Drawing or Sample with
other Shop Drawings and Samples and with the
requirements of the Work and the Contract Documents.
2. Each submittal shall bear a stamp or specific
written indication that CONTRACTOR has satisfied
CONTRACTOR’s obligations under the Contract
Documents with respect to CONTRACTOR’s review and
approval of that submittal.
3. At the time of each submittal, CONTRACTOR
shall give ENGINEER specific written notice of such
variations, if any, that the Shop Drawing or Sample
submitted may have from the requirements of the Contract
Documents, such notice to be in a written communication
separate from the submittal; and, in addition, shall cause
a specific notation to be made on each Shop Drawing and
Sample submitted to ENGINEER for review and approval
of each such variation.
E. ENGINEER’s Review
1. ENGINEER will timely review and approve Shop
Drawings and Samples in accordance with the schedule of
Shop Drawings and Sample submittals acceptable to
ENGINEER. ENGINEER’s review and approval will be
only to determine if the items covered by the submittals
will, after installation or incorporation in the Work, conform
to the information given in the Contract Documents
00700 - 24