Bravo & Brava • 1995 To 2000

14 If necessary, remove and clean the baffle
plate fitted inside the cover. If this is
particularly in need of cleaning, also check the
breather pipe stub which was removed in
paragraph 2. When refitting the stub, check
the condition of the O-rings which seal the
stub to the cover, and renew if necessary.
Refitting
15 Locate the main seal in the cover, making
sure it is correctly seated in its groove (see
illustration).
16 Apply a little sealant to the joints between
the camshaft front bearing cap (nearest the
sprockets) and the cylinder head (see
illustration).
17 Lower the cover into position on the
cylinder head, making sure the seals are not
displaced.
18 Insert the bolts and tighten them
progressively in a diagonal sequence to the
specified torque.
19 Refit all components removed for access,
using a reversal of the removal procedure.
7 Camshaft oil seals - §^
renewal