Bravo & Brava • 1995 To 2000

11*14 Bodywork and fittings
18.3a Using a pair of pliers to unclip the
plastic fastener that secures the front
window glass to the regulator mechanism
18.5a Remove the front door inner
moulding ...
18.9a Disconnect the wiring ...
18.3b The plastic clip removed from the
end of the plastic pin
18.6 Tilt the front window glass forwards and
remove it upwards
18.9b ... then unscrew the bolts ...
18.3c The front window glass has a hole
which engages with the plastic pin on the
regulator mechanism
down the loop, however, take care not to
break the plastic (see illustrations). If it is
tight, spray the clip with a little WD-40 before
removing the clip. Support the glass on a
block of wood, or use adhesive tape to hold it
in its raised position.
4 Unbolt and remove the security plate.
5 Carefully remove the inner and outer
mouldings from the upper section of the door,
then lower the window and pull up the rear
window glass rubber guide moulding from the
rear guide channel (see illustrations).
6 Tilt the window glass forwards and
withdraw the upper rear corner of the glass
from the outside of the door (see illustration).
Refitting
7 Refitting is a reversal of removal. Before
refitting the inner trim panel, check the
operation of the window by temporarily
reconnecting the switch wiring and switching
on the ignition.
Front door window regulator
Removal
8 Remove the window glass as described in
paragraphs 1 to 5.
9 Disconnect the wiring from the motor on
electrically-operated windows, then unscrew the
5 regulator mounting bolts, then withdraw the
regulator complete with motor through the
aperture in the door inner panel (see
illustrations).
18.9c ... and withdraw the front door
window regulator and motor