Bravo & Brava • 1995 To 2000

6.18a Unscrew the mounting bolts ...
Unscrew the bolts and withdraw the
cluster from inside the loadspace (see
illustrations).
All models
19 Refitting is a reversal of removal, however,
on 5-door models check that the cluster lens
is a snug fit on the outer body panel. If
necessary, turn the 4 adjustment bolts on the
mounting plate to position the lens correctly
(see illustration).
High-level stop light bulbs
20 The procedure is described as part of the
bulb renewal procedure in Section 4.
7.4 Removing the cover from the
fuses/relays
7.6b ... and two lower screws ...
6.18b ... then withdraw the rear light
cluster from inside the loadspace
Rear number plate light
21 The procedure is described as part of the
bulb renewal procedure in Section 4.
7 Instrument panel - ^
removal and refitting g$
Right-hand drive models
Removal
1 Disconnect the battery negative (earth) lead
(see Disconnecting the battery).
2 Undo the screws and remove the lower
shroud from the steering column.
7.5 Removing the instrument panel
surround outer screw
7.6c ... then disconnect the wiring from
the panel lighting rheostat...
Body electrical systems 12*11
6.19 Adjusting the rear light cluster on its
mounting plate
3 Undo the screws and remove the upper
shroud from the steering column.
4 Undo the screws and remove the cover
from the fuses/relays located on the driver's
side of the instrument panel (see illustration).
5 Working through the fuse/relay cover hole,
undo the screw securing the outer end of the
instrument panel surround to the facia (see
illustration).
6 Undo the 3 upper and 2 lower screws and
withdraw the surround from the facia.
Disconnect the wiring from the headlight adjustment
and panel lighting rheostats, and place
the surround to one side (see illustrations).
7 Undo the four screws and withdraw the
instrument panel from the facia, then
7.6a Unscrew the three upper ...
7.6d ... and headlight adjustment switch