Bravo & Brava • 1995 To 2000

Bodywork and fittings 11 »23
23.19 Removing the screws securing the 23.20a Undo the screws ... 23.20b ... remove the trim ...
heater controls to the facia
19 Undo the screws securing the heater
controls to the facia (see illustration). There
are four screws.
20 Open the glovebox lid, then remove the
upper trim from inside the glovebox. Unscrew
the mounting bolts and withdraw the
glovebox from the facia (see illustrations).
21 Remove the left-hand side air vent from
the end of the facia, using a screwdriver in the
glovebox aperture to unscrew the lower
mounting screws (see illustrations).
22 Unscrew the facia mounting bolts
accessible through the vent and instrument
panel apertures (see illustration).
23 Unscrew the facia lower mounting bolts at
each end of the facia (see illustration). If
necessary for access to the bolts, undo the
screws and remove the trim panels located on
the outer sides of the footwells.
24 Carefully prise out the speaker grilles from
both sides of the facia, taking care not to
damage the facia material.
25 In the grille aperture on each side,
unscrew the speaker mounting screws,
withdraw the speakers, and disconnect the
wiring.
26 With the speakers removed, unscrew the
facia mounting bolts now visible (see
illustration).
27 Unscrew the centre and top facia
mounting bolts (see illustrations).
23.20c ... and withdraw the glovebox
from the facia
23.21b ... and remove the left-hand side
air vent
23.21a Undo the screws ...
23.22 Removing the facia mounting bolt
located in the instrument panel aperture
23.23 Removing the facia lower mounting 23.26 Unscrew the facia mounting bolts in 23.27a Unscrew the centre bolt...
bolts the speaker apertures