Bravo & Brava • 1995 To 2000
Bravo & Brava • 1995 To 2000
Bravo & Brava • 1995 To 2000
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
w r x<br />
18.13 Disconnecting the plastic clip from<br />
the end of the plastic pin<br />
Refitting<br />
10 Refitting is a reversal of removal.<br />
Rear door window glass<br />
Removal<br />
11 Fully open the window and note the<br />
position of the regulator handle.<br />
12 Remove the door inner trim panel and the<br />
sealing sheet, as described in Section 14.<br />
13 Working through the aperture in the door<br />
inner panel, pull down the plastic fastener clip<br />
and release the window glass from the pin on<br />
the regulator arm (see illustration). If it is<br />
tight, spray the clip with a little WD-40 before<br />
removing the clip. Support the glass on a<br />
block of wood, or use adhesive tape to hold it<br />
in its raised position.<br />
18.15a Unscrew the rear bolt...<br />
18.14a Unscrew the bolts ...<br />
14 Unbolt and remove the security plate (see<br />
illustrations).<br />
15 Remove the window glass rear guide<br />
channel by unscrewing the retaining bolts<br />
located on the rear edge of the door and on<br />
the inner panel (see illustrations).<br />
16 Carefully remove the inner and outer<br />
mouldings from the upper section of the door.<br />
Unbolt the outer triangular plastic cover, then<br />
lower the window and pull up the rear window<br />
glass rubber guide moulding (see<br />
illustrations).<br />
17 Lift the window glass and withdraw it from<br />
the outside of the door (see illustration).<br />
Refitting<br />
18 Refitting is a reversal of removal. Before<br />
refitting the inner trim panel, check the<br />
— T a<br />
18.15b ... and inner panel bolt...<br />
Bodywork and fittings 11 «15<br />
18.14b ... and remove the security plate<br />
from the rear door<br />
operation of the window by temporarily<br />
refitting the regulator handle.<br />
Rear door window regulator<br />
Removal<br />
19 Fully open the window and note the<br />
position of the regulator handle.<br />
20 Remove the door inner trim panel and the<br />
sealing sheet, as described in Section 14.<br />
21 Working through the aperture in the door<br />
inner panel, pull down the plastic fastener clip<br />
and release the window glass from the pin on<br />
the regulator arm. If it is tight, spray the clip<br />
with a little WD-40 before removing the clip.<br />
Support the glass on a block of wood, or use<br />
adhesive tape to hold it in its raised position.<br />
22 Unbolt and remove the security plate.<br />
18.15c ... and remove the rear window<br />
glass rear guide channel from the door