Fast Models Reference Manual - ARM Information Center

Peripheral and Interface Components
5.3.5 SGSignal2AMBAPVSignal component
The SGSignal2AMBAPVSignal component converts from Signal to AMBAPVSignal
protocols.
Figure 5-9 shows a view of the component in System Canvas.
This component is written in LISA.
Figure 5-9 SGSignal2AMBAPVSignal in System Canvas
Ports
Table 5-13 describes the SGSignal2AMBAPVSignal ports.
Name Port protocol Type Description
Table 5-13 SGSignal2AMBAPVSignal ports
sg_signal_s Signal Slave Handles incoming signal state changes.
amba_pv_signal_m AMBAPVSignal Master Output master port for connection to
top-level AMBAPVSignal master port.
Converted signal state changes are sent
out through this port.
Additional protocols
The SGSignal2AMBAPVSignal component has no additional protocols.
Parameters
The SGSignal2AMBAPVSignal component has no configuration parameters.
Registers
The SGSignal2AMBAPVSignal component has no registers.
Debug features
The SGSignal2AMBAPVSignal component has no debug features.
Verification and testing
The SGSignal2AMBAPVSignal component has been tested as part of the SystemC Export
example systems. These systems can be found in %PVLIB_HOME%\examples\SystemCExport. On
Linux, look in the $PVLIB_HOME/examples/SystemCExport directory.
Performance
The SGSignal2AMBAPVSignal component is not expected to significantly affect the
performance of a PV system.
ARM DUI 0423J Copyright © 2008-2011 ARM. All rights reserved. 5-25
ID051811
Non-Confidential