Fast Models Reference Manual - ARM Information Center

Peripheral and Interface Components
configure any number of pins as interrupt sources. Refer to the component documentation for
more details. See ARM PrimeCell General Purpose Input/Output (PL061) Technical Reference
Manual.
Figure 5-33 shows a view of the component in System Canvas.
This component is written in LISA+.
Figure 5-33 PL061_GPIO in System Canvas
Ports
Table 5-50 provides a brief description of the PL061_GPIO ports. Refer to the component
documentation for more details.
Name Port protocol Type Description
Table 5-50 PL061_GPIO ports
pvbus PVBus Slave Slave port for connection to PV bus
master/decoder.
GPIO_In Value Slave Input lines a .
GPIO_Out Value Master Output lines a .
GPIO_Intr Signal Master Interrupt signal indicating to an interrupt
controller that an interrupt occurred in
one or more of the GPIO_In lines.
GPIO_MIS Value Master Indicates the masked interrupt status a .
a. Only the lower end eight bits [7:0] are used.
Additional protocols
The PL061_GPIO component has no additional protocols.
Parameters
The PL061_GPIO component has no parameters.
ARM DUI 0423J Copyright © 2008-2011 ARM. All rights reserved. 5-64
ID051811
Non-Confidential