Specs

Bridgestone Retail Operations, LLC
PROJECT MANUAL
Version: January 2012
SECTION 01002
GENERAL PROJECT REQUIREMENTS
A. GENERAL
1. Contractor and all Subcontractors are directed and required to read the entire project manual
and Standard General Conditions included herein in order to familiarize themselves with all
items related to their individual crafts.
2. The BFS Retail & Commercial Operations, LLC, Standard General Conditions as part of the
Contract Form are a part of these specifications and the contractors will be held responsible
for their fulfillment. Non-reading of said Standard General Conditions by Contractor or
Subcontractors shall not be accepted as an excuse for failure to comply with them.
3. Contractor shall keep one complete up-to-date set of Drawings and Specifications on the job
at all times, including all voided sheets for ready reference in addition to other copies of
Drawings and Specifications used by mechanics on actual construction work.
B. DEFINITIONS
1. Wherever the words "Owner and Contractor” are used in this Project Manual, it refers to
those entities as defined on the Contract Form.
C. TERMS INCLUDED
1. Any item or construction detail not shown on the Drawings but called for in the Specifications
and any item or construction detail shown on the Drawings and not mentioned in the
Specifications are a part of this contract just as much as if they are shown and mentioned on
both Drawings and Specifications.
D. CHANGES
1. Any changes or additions to the Contract, Drawings or Specifications shall be in writing on
Owner's "Change Order" form. Contractor and all Subcontractors are hereby given notice
that no extras will be recognized unless they are authorized in writing on said form by
Owner's Field Representative.
E. DISCREPANCIES, CONTRADICTIONS AND AMBIGUITIES
1. Any discrepancies, contradictions or ambiguities on the Drawings and/or specifications or
between the Drawings and specifications shall be called to the Owner's attention at time of
submitting bid and before awarding of contract. If this procedure is not followed, the Owner
reserves the right to rule on any discrepancies, contradictions or ambiguities in the
Drawings and Specifications after awarding of contract and Owner's decision shall be final.
Contractor shall have no claim for extra compensation because of decision.
2. No extra charge will be allowed on account of differences between actual dimensions and
measurements indicated on Drawings. Differences which may be found shall be submitted to
Owner for his consideration before proceeding with the work.
GENERAL PROJECT REQUIREMENTS 01002 - Page 1 of 7