Specs

Bridgestone Retail Operations, LLC
PROJECT MANUAL
Version: January 2012
3. Performance:
a. Visible light transmittance 70% or greater.
b. Light to solar gain ratio 1.25 or greater.
B. Edge Seal Construction: Aluminum, bent and soldered corners.
C. Edge Seal Material: Black Color.
2.03 FROSTED COLORED GLASS
A. ¼” glass to comply with requirements specified in this Section.
B. PPG Pacifica (Dark Blue) with acid etching on #2 side.
2.04 GLAZING COMPOUNDS
A. Butyl Sealant: Single component; Shore A hardness of 10 to 20; black color; non-skinning.
B. Acrylic Sealant: Single component, solvent curing, non-bleeding; cured Shore A hardness of 15 to
25; color as selected.
C. Silicone Sealant: Single component; chemical curing; capable of water immersion without loss of
properties; non-bleeding, non-staining; cured Shore A hardness of 15 to 25; color as selected.
2.05 GLAZING ACCESSORIES
A. Manufacturer's standard type.
PART 3 EXECUTION
3.01 INSTALLATION
A. Install in accordance with manufacturers instructions.
3.02 CLEANING
A. Remove glazing materials from finish surfaces.
B. Remove labels after Work is complete.
C. Clean glass and adjacent surfaces.
3.03 PROTECTION OF FINISHED WORK
A. After installation, mark pane with an 'X' by using removable plastic tape or paste.
END OF SECTION
GLAZING 08800 - Page 2 of 2