Specs

Bridgestone Retail Operations, LLC
PROJECT MANUAL
Version: January 2012
SECTION 16140
WIRING DEVICES
PART 1 GENERAL
1.01 SECTION INCLUDES
A. Wall switches.
B. Wall dimmers.
C. Receptacles.
D. Device plates and box covers.
1.02 QUALITY ASSURANCE
A. Conform to requirements of NFPA 70.
B. Products: Provide products listed and classified by Underwriters Laboratories, Inc. as suitable for
the purpose specified and indicated.
PART 2 PRODUCTS
2.01 WALL SWITCHES
A. Wiring devices shall be of specification grade and the manufactured products of Hubbell, Pass
and Seymour, Leviton, Eagle or Slater. Each receptacle shall be constructed to include a
grounding pole from which a wired connection to ground shall be provided.
B. Switches shall be as follows:
1. Single pole- Hubbell 1221-I
2. Two pole - Hubbell 1222-I
3. Three way - Hubbell 1223-I
C. Toggle switches shall be rated 20 ampere, 120-277 volts, except where otherwise shown on the
drawings.
D. Duplex receptacles
1. Standard - Hubbell 5362-I
2. Isolated Ground - Hubbell IG2162 (Orange)
3. Ground Fault Interrupter - Hubbell GF5362I
Leviton, Seymour, Slater, or Eagle will be considered as approved equals.
E. Exterior weatherproof outlets
1. Grade level (not installed on rooftops for service rooftop mechanical equipment)
weatherproof outlets will be ground fault interrupter outlets mounted in weatherproof box
and cover as manufactured by Pass & Seymour #4600 weatherproof heavy cast
Aluminum Cover with #4600-26 enclosure with mounting plate tor GFCI outlet. All
enclosures shall be keyed alike.
2. Rooftop level weatherproof outlets will be ground fault interrupter outlets mounted in a
weatherproof box and cover.
F. Provide plates for all outlets, with opening configuration suitable for devices to be covered.
Plates shall be in place with screws finished to match the plates. Plates will be brushed stainless
steel.
G. All plates used for motor starting switches shall be with engraving denoting its function.
H. Covers for "FS" or "FD" boxes shall be corrosion resistant.
PART 3 EXECUTION
3.01 INSTALLATION
A. Install in accordance with NECA "Standard of Installation."
B. Install devices plumb and level.
WIRING DEVICES 16140 - Page 1 of 2