Specs

Bridgestone Retail Operations, LLC
PROJECT MANUAL
Version: January 2012
SECTION 08112
COMMERCIAL STEEL DOORS AND FRAMES
PART 1 GENERAL
1.01 SECTION INCLUDES
A. Hollow metal doors, frames, and accessories.
1.02 RELATED SECTION
A. Section 08710 – Door Hardware.
1.03 QUALITY ASSURANCE
A. Manufacturer Qualifications: Minimum five years documented experience-producing products
specified in this section and Member of HMMA.
1.04 SUBMITTALS
A. Sustainable Submittals: No submittals are required. Refer to Section 01352 for Sustainable
recommendations on this project.
PART 2 PRODUCTS
2.01 MATERIALS
A. Steel Sheet: One of the following:
1. Cold-rolled steel sheet conforming to ASTM A 366/A 366M, commercial quality.
2. Hot-rolled steel sheet conforming to ASTM A 569/A 569M, pickled and oiled, commercial
quality.
B. Galvanized Steel Sheet: ASTM A 653/A 653M, commercial quality, minimum G60/Z180 zinc
coating.
C. Insulating Material: Glass fiber or rock wool.
2.02 DOOR AND FRAME ASSEMBLIES
A. Door Construction: A standard 3 feet by 7 feet door shall meet requirements of ANSI A250.4
procedure for level A doors for 1,000,000 cycles and twist test of 300 pounds; provide test reports.
B. Fire-Rated Assemblies: Complying with NFPA 80; constructed as tested in accordance with NFPA
252 for specified fire resistance ratings.
1. Listed or classified by UL and bearing the fire rating label or seal of that agency.
2.03 DOORS
A. Exterior Doors: Galvanized steel face sheets of minimum 16 gage thickness.
1. Thickness: 1-3/4 inches.
2. Sizes: Indicated on drawings.
3. Fill spaces between stiffeners with insulating material.
B. Interior Doors: Steel face sheets of minimum 18 gage thickness.
1. Thickness: 1-3/4 inches.
2. Sizes: Indicated on drawings.
3. Non-Insulated.
C. Face and Core Fabrication: Visible seams on face sheets not permitted.
1. Stiffen face sheets with continuous vertical sections, formed of minimum 22 gage steel sheet,
which, upon assembly, span full thickness of interior space between door faces.
2. Space stiffeners 6 inches apart, maximum; spot-weld to both face sheets at 5 inches,
maximum, on center vertically.
D. Vertical Edge Fabrication: Join face sheets at vertical edges by continuous welding on each edge,
extending full door height; grind, fill, and dress welds to provide smooth flush surface.
1. Single acting swing doors: Bevel each vertical edge 1/8 inch in 2 inches.
COMMERCIAL STEEL DOORS AND FRAMES 08112 - Page 1 of 3