Specs

Bismarck Real Estate Partners, Inc.
PROJECT MANUAL
PART 3 - EXECUTION
3.01 ERECTION
A. Metal roof deck shall be erected and fastened in accordance with the SDI Specifications and
the manufacturer's specifications and erection layouts. Metal roof deck shall be continuous
over at least three spans. Cutting openings through the deck which are less than 16 square
feet in area and all skew cutting shall be performed in the field. All cutting of metal roof deck
shall be by metal cutting saw only. No torch cuts or jagged edges are acceptable.
B. Top and bottom faces and edges of deck materials where cuts have been made including all
deck welds shall have prime coating touched-up with a heavy coat of the same type of paint
as the shop coat.
C. Repair Painting: Wire brush and clean rust spots, welds, and abraded areas on both surfaces
of prime-painted deck immediately after installation, and apply repair paint.
D. Do not hang or support any loads from metal roof deck.
E. When stored on site, keep deck covered, clean, and protected against dirt, mud and rust. All
deck damaged, dented, chipped, punctured or otherwise deformed (including weld blow holes
in deck from welding) during shipping, storage or erection to render it unusable or unsightly
shall be replaced at no additional cost to the Owner. The Owner Representative shall be the
sole judge as to whether metal roof deck must be replaced.
END OF SECTION
METAL DECK 05320 - Page 2 of 2