Specs

More documents

Recommendations

Info

Bridgestone Retail Operations, LLC PROJECT MANUAL Version: January 2012 SECTION 01400 QUALITY REQUIREMENTS PART 1 GENERAL 1.01 SECTION INCLUDES A. References and standards. B. Quality assurance submittals. C. Control of installation. D. Testing and inspection services. 1.02 STANDARDS and REFERENCES A. Except where the Contract Documents include more stringent requirements, applicable industry standards have the same force and effect as if bound or copied directly into the Contract Documents to the extent referenced. B. Each entity engaged in construction on the Project is required to be familiar with industry standards applicable to its construction activity. Copies of applicable standards are not bound with the Contract Documents. C. Where copies of standards are needed to perform a required construction activity, the contractor shall obtain copies directly from the publication source at his own expense. D. Trade association names and titles of general standards are frequently abbreviated. The following acronyms or abbreviations, as referenced in the Contract Documents are defined to mean the associated name. Master Listing of Specification Standard and Reference Sources. AABC MN Associated Air Balance Council ABMA STD American Bearing Manufacturers Association, Inc. ACI American Concrete Institute International AISC American Institute of Steel Construction, Inc. ANSI American National Specification Institute ARI Air-Conditioning and Refrigeration Institute ASHRAE American Society of Heating, Refrigeration and Air-Conditioning Engineers, Inc. ASME American Society of Mechanical Engineers ASSE American Society of Sanitary Engineering ASTM American Standard Testing Methods AWS American Welding Society AWWA American Water Works Association CISPI Cast Iron Soil Pipe Institute GA Gypsum Association IEEE Institute of Electrical and Electronic Engineers IIAR International Institute of Ammonia Refrigeration IMIAWC International Masonry Industry All-Weather Council MSS Manufacturers Standardization Society of the Valve and Fitting Industry, Inc. NEBB National Environmental Balancing Bureau NECA National Electrical Contractors Association NEMA National Electrical Manufacturers Association NETA International Electrical Testing Association NFPA National Fire Protection Association PDI Plumbing and Drainage Institute SMACNA Sheet Metal and Air Conditioning Contractors' National Association UL Underwriters Laboratories, Inc. QUALITY REQUIREMENTS 01400 - Page 1 of 11
Bridgestone Retail Operations, LLC PROJECT MANUAL Version: January 2012 E. For products and workmanship specified, comply with requirements of the applicable reference and standard, except when more rigid requirements are specified or are required by applicable codes. F. Conform to reference standard of date of issue current on date of Contract Documents, except where a specific date is established by applicable code. G. Should specified reference standards have conflict with Contract Documents, request clarification from the Owner's Representative before proceeding. H. Reference BSRO’s Testing Specification (Construction Material Testing & Observation Agreement Requirements) by BSRO’s contract testing agency. 1.03 TESTING AND INSPECTION AGENCIES A. G.C. to coordinate scheduling of testing agency in accordance to prescribed observations. B. Coordination of agency in no way relieves Contractor of obligation to perform Work in accordance with requirements of Contract Documents. C. BSRO Employed Agency: 1. Testing agency: Comply with requirements of ASTM C802. 2. Inspection agency: Comply with requirements of ASTM D290. 3. Laboratory: Authorized to operate in State in which Project is located. 4. Laboratory Staff: Maintain a full time registered Engineer on staff to review services. 5. Testing Equipment: Calibrated at reasonable intervals with devices of an accuracy traceable to either National Bureau of Standards or accepted values of natural physical constants. PART 2 EXECUTION 2.01 CONTROL OF INSTALLATION A. Monitor quality control over suppliers, manufacturers, products, services, site conditions, and workmanship, to produce Work of specified quality. B. Comply with manufacturers' instructions, including each step in sequence. C. Should manufacturers' instructions conflict with Contract Documents, request clarification from Owner's Representative before proceeding. D. Comply with specified standards as minimum quality for the Work except where more stringent tolerances, codes, or specified requirements indicate higher standards or more precise workmanship. 2.02 TOLERANCES A. Comply with manufacturers' tolerances. Should manufacturers' tolerances conflict with Contract Documents, request clarification from Owner's Representative before proceeding. 2.03 TESTING AND INSPECTION A. Contractor Responsibilities: 1. Deliver to agency at designated location, adequate samples of materials proposed to be used which require testing, along with proposed mix designs. 2. Cooperate with laboratory personnel, and provide access to the Work and to manufacturers' facilities. 3. Provide incidental labor and facilities: a. To provide access to Work to be tested/inspected. b. To obtain and handle samples at the site or at source of Products to be tested/inspected. c. To facilitate tests/inspections. d. To provide storage and curing of test samples. B. Re-testing required because of non-conformance to specified requirements shall be performed by the same agency. 2.04 DEFECT ASSESSMENT A. Replace Work or portions of the Work not conforming to specified requirements. B. If, in the opinion of the Owner's Representative, it is not practical to remove and replace the Work, the Owner's Representative will direct an appropriate remedy or adjust payment. C. Refer to Invitation To Bid Section 17: Special Procedures, paragraph e (page 12). QUALITY REQUIREMENTS 01400 - Page 2 of 11
Page 1:
Bridgestone Retail Operations, LLC
Page 5 and 6:
Bismarck Real Estate Partners, Inc.
Page 7 and 8:
Bismarck Real Estate Partners, Inc.
Page 9 and 10:
Page 11 and 12:
Page 13:
Page 16 and 17:
Page 18 and 19:
Page 21 and 22:
Page 23 and 24:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Bridgestone Retail Operations LLC..
Page 38 and 39:
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100: Bridgestone Retail Operations LLC..
Page 103 and 104: Bridgestone Retail Operations, LLC
Page 128: Bridgestone Retail Operations, LLC
Page 202 and 203:
Page 204 and 205:
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 228 and 229:
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
Page 236 and 237:
Page 238:
Page 241 and 242:
Page 244 and 245:
Page 246 and 247:
Page 248:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 262 and 263:
Page 264:
Page 267 and 268:
Bridgestone Retail Operations LLC P
Page 270 and 271:
Page 272 and 273:
Page 274:
Page 277 and 278:
Page 280 and 281:
Page 282:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 292:
Page 296 and 297:
Page 298:
Page 301 and 302:
Page 303 and 304:
Page 305 and 306:
Page 308 and 309:
Page 310 and 311:
Page 312:
Page 315 and 316:
Page 317 and 318:
Page 320 and 321:
Page 322:
Page 325 and 326:
Page 328 and 329:
Page 330:
Page 333 and 334:
Page 336 and 337:
Page 338 and 339:
Page 340:
Page 343 and 344:
Page 345 and 346:
Page 347 and 348:
Page 349 and 350:
Page 351 and 352:
Page 353 and 354:
Page 356 and 357:
Page 358 and 359:
Page 360:
Page 363 and 364:
Page 366 and 367:
Page 368 and 369:
Page 370 and 371:
Page 372 and 373:
Page 374 and 375:
Page 376 and 377:
Page 378 and 379:
Page 380 and 381:
Page 382 and 383:
Page 384 and 385:
Page 386:
Page 389 and 390:
Page 391 and 392:
Page 393 and 394:
Page 395 and 396:
Page 397 and 398:
Page 399 and 400:
Page 402 and 403:
Page 404 and 405:
Page 406 and 407:
Page 408 and 409:
Page 410 and 411:
Page 412 and 413:
Page 414 and 415:
Page 416:
Page 419 and 420:
Page 422 and 423:
Page 424 and 425:
Page 426 and 427:
Page 428:
Page 431 and 432:
Page 433 and 434:
Page 436 and 437:
Page 438 and 439:
Page 440 and 441:
Page 442 and 443:
Page 444 and 445:
Page 446 and 447:
Page 448 and 449:
Page 450 and 451:
Page 452 and 453:
Page 454 and 455:
Page 456 and 457:
Page 458 and 459:
Page 460:
Page 463 and 464:
Page 465 and 466:
Page 467 and 468:
Page 469 and 470:
Page 471 and 472:
Page 473 and 474:
Page 475 and 476:
Page 477 and 478:
Page 479 and 480:
Page 481 and 482:
Page 483 and 484:
Page 485 and 486:
Page 487 and 488:
Page 489 and 490:
Page 491 and 492:
Page 493 and 494:
Page 495 and 496:
Page 498 and 499:
Page 500 and 501:
Page 502:
Page 506 and 507:
Page 508 and 509:
Page 510:
Page 513 and 514:
Page 516 and 517:
Page 518 and 519:
Page 520 and 521:
Page 522 and 523:
Page 524:
Page 527 and 528:
Page 529 and 530:
Page 531 and 532:
Page 533 and 534:
Page 536:
Page 540 and 541:
Page 542:
Page 546:
Page 549 and 550:
Page 552 and 553:
Page 554:
Page 558:
Page 562 and 563:
Page 564 and 565:
Page 566:
Page 570 and 571:
Page 572 and 573:
Page 574 and 575:
Page 576 and 577:
Page 578 and 579:
Page 580 and 581:
Page 582:
Page 585 and 586:
Page 587 and 588:
Page 589:
Page 592 and 593:
REPORT OF GEOTECHNICAL ENGINEERING
Page 594 and 595:
Proposed Bridgestone April 20, 2011
Page 596 and 597:
Page 598 and 599:
Page 600 and 601:
Page 602 and 603:
Page 604 and 605:
Page 606 and 607:
Page 608 and 609:
Page 611 and 612:
FIGURE: 3 DATE STARTED: 4/5/11 DRIL
Page 613 and 614:
Page 615 and 616:
Page 617 and 618:
Page 619 and 620:
FIGURE: 11 DATE STARTED: 4/5/11 DRI
Page 621 and 622:
APPENDIX A Laboratory Test Results
Page 623 and 624:
12 SWELL-CONSOLIDATION TEST 10 8 6
Page 625 and 626:
Page 627 and 628:
Page 629 and 630:
Page 631 and 632:
10 SWELL-CONSOLIDATION TEST 8 6 4 2
Page 633 and 634:
Page 635 and 636:
Page 637 and 638:
Page 639 and 640:
June 21, 2012 Bridgestone Retail Op
Page 641 and 642:
Bridgestone/Firestone - Lakewood, C
Page 643 and 644:
Bridgestone/Firestone - Lakewood, C
show all

Specs

Create successful ePaper yourself

Delete template?

Save as template?