10.03.2015 Views

Specs

Specs

Specs

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Bridgestone Retail Operations, LLC<br />

PROJECT MANUAL<br />

Version: January 2012<br />

C. Wire for Hangers and Tees: ASTM A 641, Class 1 zinc coating, soft temper, prestretched, with a<br />

yield stress load of at least time three design load, but not less than 12 gauge.<br />

D. Edge Moldings and Trim: Metal or extruded aluminum of types and profiles indicated or, if not<br />

indicated, manufacturer’s standard moldings for edges and penetrations, including light fixtures,<br />

that fit type of edge detail and suspension system indicated. Provide moldings with exposed flange<br />

of the same width as exposed runner.<br />

2.04 ACCESSORIES<br />

A. Support Channels and Hangers: Galvanized steel; size and type to suit application, seismic<br />

requirements, and ceiling system flatness requirement specified.<br />

PART 3 EXECUTION<br />

3.01 INSTALLATION - SUSPENSION SYSTEM<br />

A. Install suspension system in accordance with ASTM C 636, ASTM E 580, and manufacturer's<br />

instructions.<br />

B. Support fixture loads using supplementary hangers located within 6 inches of each corner, or<br />

support components independently.<br />

3.02 INSTALLATION - ACOUSTICAL UNITS<br />

A. Install acoustical units in accordance with manufacturer's instructions.<br />

B. Install hold-down clips on panels within 10 ft of an exterior door.<br />

END OF SECTION<br />

SUSPENDED ACOUSTICAL CEILINGS 09511 - Page 2 of 2

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!