Specs

Bridgestone Retail Operations, LLC
PROJECT MANUAL
Version: January 2012
3.05 INSTALLATION – BASE
A. Fit joints tightly and make vertical. Maintain minimum dimension of 18 inches between joints.
B. Miter internal corners. At external corners, use premolded units. At exposed ends, use
premolded units.
3.06 CLEANING
A. Remove and replace all defective and damaged materials, including those which failed to bond to
the substrate.
B. Sweep and vacuum floor after installation.
C. Clean in accordance with manufacturer's instructions, removing all exposed adhesive and visible
blemishes. Reclean surfaces soiled prior to acceptance of project at no additional cost to OWNER.
1. Do not wash floor until after time period recommended by manufacturer.
D. Seal and wax flooring in accordance with manufacturer's recommendations.
E. Dispose of sealant and adhesive remnants and containers in accordance with applicable
regulations, and protective coverings.
3.07 PROTECTION
A. Prohibit traffic on floor finish for period recommended by manufacturer, but for at least 48 hours
after installation.
B. Do not place any equipment, casework or furnishings on resilient flooring until the flooring adhesive
is fully cured and dried, and the flooring is tightly bonded to the substrate.
C. Protect installed flooring from until date of Final Acceptance. Remove protection immediately prior
to acceptance.
D. Protect work of other trades and existing work; correct damage by cleaning, repairing or replacing,
as acceptable to Project Manager
3.08 WASTE MANAGEMENT
A. Separate waste in accordance with the requirements of Section 01570 - Construction Waste
Management.
END OF SECTION
RESILIENT FLOORING 09650 - Page 3 of 3