Specs

More documents

Recommendations

Info

Bridgestone Retail Operations, LLC PROJECT MANUAL Version: January 2012 which provides the NAFS certification. F. Skylights must be certified by the NFRC. G. Skylights must be certified by the NAFS. H. Smoke Hatch/Smoke Venting Skylights must be Factory Mutual approved. 2.05 INSPECTION A. Firestone will conduct a “First Article Inspection” of vendor’s formal submission from a representative production batch/run. This inspection includes subjecting the submission to full QA/QC and physical testing (including dimensions), as well as examination of all packaging, labeling and lot numbering. B. Firestone reserves the right to sample any material shipped and test any provision of the referenced product specification at any time. 2.06 PACKAGING AND MARKING A. Each dome shall be marked with a small 2” x 1-1/2” label on the aluminum frame. See attachment. B. Skylight daylighting components shall be carefully packaged on wooden skids. PART 3 EXECUTION 3.01 EXAMINATION A. Prior to beginning work of this section, an authorized representative shall examine the associated support structure to determine that it is properly prepared and ready to received the skylight work included herein. No installation shall proceed until any discrepancies have been resolved. 3.02 PREPARATION A. Aluminum surfaces in contact with masonry, concrete or dissimilar materials, if not organically coated, shall be given a heavy coat of zinc chromate or bituminous paint. 3.03 INSTALLATION A. Skylight installation shall be the sole responsibility of the General Contractor in strict accordance with the skylight manufacturer instructions. B. Install skylights plumb, true without warping or racking of panels. C. Anchor system in strict accordance with manufacturer’s instruction. D. During erection, provide for thermal movement with a minimum ambient air temperature shift of 100 0 Farenheight without creating undue stresses. E. Apply sealant where required by manufacturer. Before application, clean surfaces as recommended by manufacturer. 3.04 TOLERANCES A. All parts of the work, when completed, shall be within the following tolerances: 1. Maximum variation from plane or location shown on approved shop drawings: 1/8” per 12 METAL FRAMED SKYLIGHT / SMOKE VENT 08625 - Page 5 of 6
Bridgestone Retail Operations, LLC PROJECT MANUAL Version: January 2012 feet of length or ½” in total length. 2. Maximum offset from true alignment between two members abutting end-to-end, edge-toedge in line or separated by less than 3”: 1/32”. 3.05 CLEANING AND PROTECTION A. Glazing panels shall be left in scratch free condition inside and out. B. Remove all debris created by this work. END OF SECTION METAL FRAMED SKYLIGHT / SMOKE VENT 08625 - Page 6 of 6
Page 1:
Bridgestone Retail Operations, LLC
Page 5 and 6:
Bismarck Real Estate Partners, Inc.
Page 7 and 8:
Bismarck Real Estate Partners, Inc.
Page 9 and 10:
Page 11 and 12:
Page 13:
Page 16 and 17:
Page 18 and 19:
Page 21 and 22:
Page 23 and 24:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Bridgestone Retail Operations LLC..
Page 38 and 39:
Page 40 and 41:
Page 42 and 43:
Page 44 and 45:
Page 46 and 47:
Page 48 and 49:
Page 50 and 51:
Page 52 and 53:
Page 54 and 55:
Page 56 and 57:
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100:
Page 103 and 104:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146:
Page 149 and 150:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162:
Page 165 and 166:
Page 168:
Page 172 and 173:
Page 174 and 175:
Page 176:
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Page 190:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 202 and 203:
Page 204 and 205:
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 228 and 229:
Page 230 and 231:
Page 232 and 233:
Page 234 and 235:
Page 236 and 237:
Page 238:
Page 241 and 242:
Page 244 and 245:
Page 246 and 247:
Page 248:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 262 and 263:
Page 264:
Page 267 and 268:
Bridgestone Retail Operations LLC P
Page 270 and 271:
Page 272 and 273:
Page 274:
Page 277 and 278:
Page 280 and 281:
Page 282:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 292:
Page 296 and 297:
Page 298:
Page 301 and 302:
Page 303 and 304:
Page 305 and 306:
Page 308 and 309:
Page 310 and 311:
Page 312:
Page 315 and 316:
Page 317 and 318:
Page 320 and 321:
Page 322:
Page 325 and 326:
Page 328 and 329:
Page 330:
Page 333 and 334: Bridgestone Retail Operations, LLC
Page 340: Bridgestone Retail Operations, LLC
Page 404 and 405: Bridgestone Retail Operations LLC P
Page 436 and 437:
Page 438 and 439:
Page 440 and 441:
Page 442 and 443:
Page 444 and 445:
Page 446 and 447:
Page 448 and 449:
Page 450 and 451:
Page 452 and 453:
Page 454 and 455:
Page 456 and 457:
Page 458 and 459:
Page 460:
Page 463 and 464:
Page 465 and 466:
Page 467 and 468:
Page 469 and 470:
Page 471 and 472:
Page 473 and 474:
Page 475 and 476:
Page 477 and 478:
Page 479 and 480:
Page 481 and 482:
Page 483 and 484:
Page 485 and 486:
Page 487 and 488:
Page 489 and 490:
Page 491 and 492:
Page 493 and 494:
Page 495 and 496:
Page 498 and 499:
Page 500 and 501:
Page 502:
Page 506 and 507:
Page 508 and 509:
Page 510:
Page 513 and 514:
Page 516 and 517:
Page 518 and 519:
Page 520 and 521:
Page 522 and 523:
Page 524:
Page 527 and 528:
Page 529 and 530:
Page 531 and 532:
Page 533 and 534:
Page 536:
Page 540 and 541:
Page 542:
Page 546:
Page 549 and 550:
Page 552 and 553:
Page 554:
Page 558:
Page 562 and 563:
Page 564 and 565:
Page 566:
Page 570 and 571:
Page 572 and 573:
Page 574 and 575:
Page 576 and 577:
Page 578 and 579:
Page 580 and 581:
Page 582:
Page 585 and 586:
Page 587 and 588:
Page 589:
Page 592 and 593:
REPORT OF GEOTECHNICAL ENGINEERING
Page 594 and 595:
Proposed Bridgestone April 20, 2011
Page 596 and 597:
Page 598 and 599:
Page 600 and 601:
Page 602 and 603:
Page 604 and 605:
Page 606 and 607:
Page 608 and 609:
Page 611 and 612:
FIGURE: 3 DATE STARTED: 4/5/11 DRIL
Page 613 and 614:
Page 615 and 616:
Page 617 and 618:
Page 619 and 620:
FIGURE: 11 DATE STARTED: 4/5/11 DRI
Page 621 and 622:
APPENDIX A Laboratory Test Results
Page 623 and 624:
12 SWELL-CONSOLIDATION TEST 10 8 6
Page 625 and 626:
Page 627 and 628:
Page 629 and 630:
Page 631 and 632:
10 SWELL-CONSOLIDATION TEST 8 6 4 2
Page 633 and 634:
Page 635 and 636:
Page 637 and 638:
Page 639 and 640:
June 21, 2012 Bridgestone Retail Op
Page 641 and 642:
Bridgestone/Firestone - Lakewood, C
Page 643 and 644:
Bridgestone/Firestone - Lakewood, C
show all

Specs

Create successful ePaper yourself

Delete template?

Save as template?