Specs

Bridgestone Retail Operations, LLC
PROJECT MANUAL
Version: January 2012
SECTION 07214
FOAMED-IN-PLACE INSULATION
PART 1 GENERAL
1.01 SECTION INCLUDES
A. Foamed-in-place insulation in masonry cavity walls.
1.02 RELATED SECTION
A. Section 04811 – Single Wythe Unit Masonry.
1.03 QUALITY ASSURANCE
A. Manufacturer Qualifications: Company specializing in manufacturing products of the type specified
in this section, with not less than 5 years of documented experience.
B. Applicator Qualifications: Company specializing in performing work of the type specified, with
minimum 5 years of experience and approved by the manufacturer.
1.04 SUBMITTALS
A. Sustainable Submittals: No submittals are required. Refer to Section 01352 for Sustainable
recommendations on this project.
1.05 REGULATORY REQUIREMENTS
A. Conform to applicable code for flame and smoke limitations.
PART 2 PRODUCTS
2.01 MANUFACTURERS
A. Tripolymer manufactured by C.P. Chemical Co., Inc.
B. Core-Fill-500 manufactured by Tailored Chemical Products, Inc.
C. Thermco Foam with T-17 manufactured by Thermal Corporation.
2.02 MATERIALS
A. Insulation: FHSA Non-toxic type.
1. Thermal Conductivity: ASTM C 177;
a. 0.219 k value at 75 degrees F.
2. Water Vapor Transmission: ASTM E 96; 15.5 - 16.9 perms.
3. Density: ASTM D 1622; .8 - 1.3 lb/cu ft.
4. Flame Spread and Smoke Developed Rating: ASTM E 84 5 / 0.
PART 3 EXECUTION
3.01 EXAMINATION
A. Verify work within construction spaces or crevices is complete prior to insulation application.
3.02 APPLICATION
A. Apply insulation in strict compliance with manufacturer's printed instructions.
END OF SECTION
FOAMED-IN-PLACE INSULATION 07214 - Page 1 of 1