Specs

Bridgestone Retail Operations, LLC
PROJECT MANUAL
Version: January 2012
PART 2 PRODUCTS
2.01 PANEL MATERIALS
A. Wood Particle board: NIST PS 1; AWI P-200 standard, composed of wood chips, medium
density, made with high waterproof resin binders; of grade to suit application.
2.02 MANUFACTURERS - PLASTIC LAMINATE
A. Pionite
B. Formica
C. Nevemar
D. Wilsonart
E. Substitutions: See Section 01600 - Product Requirements.
2.03 LAMINATE MATERIALS
A. Refer to Section 06067.
2.04 ACCESSORIES
A. Adhesive: FS MMM-A-130 contact adhesive.
B. Fasteners: Size and type to suit application.
C. Bolts, Nuts, Washers, Lags, Pins, and Screws: Of size and type to suit application.
D. Concealed Joint Fasteners: Threaded steel.
E. Cabinet Hardware:
1. Cabinet door hardware: Provide hinges (Stanley concealed casework hinges self
closing nickel finish), catches (Stanley magnetic catch) and pulls (Stanley cabinet
pulls satin finish aluminum) of types indicated, to accommodate each door size and
style.
2. Sliding Door Hardware: Provide sets of type indicated, including pulls to
accommodate each pair of sliding doors. Provide sliding type sets, except where
rolling types are indicated.
3. Drawer Hardware: Provide slides and pulls of types indicated, to accommodate each
drawer size and style. Equip each drawer with side-mounted, full-extension, ballbearing,
nylon roller drawer slides with load capacity of 75 lbs. per pair.
4. Locks: Provide standard pin-type or disc-type (5 pins or discs) tumbler locks, keyed
individually. Provide every other door and all drawers with locks, final location of
locks shall be approved by the Architect.
5. Shelf Supports: Where shelving is indicated as “adjustable”, provide recessed
mounted slotted-type standards and brackets of needed to support shelves with
uniform 40 lb. per sq. ft loading.
6. Exposed Hardware Finish: Except where noted otherwise, provide exposed hardware
with BHMA satin stainless steel finish.
F. Grommets: Plastic material for cut-outs.
2.05 FABRICATION
A. Shop assemble casework for delivery to site in units easily handled and to permit passage
through building openings.
B. Cap exposed plastic laminate finish edges with material of same finish and pattern.
C. Door and Drawer Fronts: 3/4 inch thick; flush style.
D. When necessary to cut and fit on site, provide materials with ample allowance for cutting.
Provide trim for scribing and site cutting.
CUSTOM CABINETS 06410 - Page 2 of 3