Specs

Bridgestone Retail Operations, LLC
PROJECT MANUAL
Version: January 2012
SECTION 06410
CUSTOM CABINETS
PART 1 GENERAL
1.01 SECTION INCLUDES
A. Special fabricated cabinet units.
B. Countertops.
C. Cabinet hardware.
D. Prefinished surfaces.
E. Preparation for installing utilities.
1.02 RELATED SECTION
A. Section 06067 – Plastic Surfacing Materials.
1.03 REFERENCES
A. AHA A135.4 - Basic Hardboard; American Hardboard Association.
B. ANSI A208.1 - Wood Particle board.
C. AWI P-200 - Architectural Woodwork Quality Standards Illustrated; Architectural Woodwork
Institute.
D. BHMA A156.9 - American National Standard for Cabinet Hardware; Builders Hardware
Manufacturer’s Association, Inc. (ANSI/BHMA A156.9).
E. FS MMM-A-130 - Adhesive, Contact; Federal Specifications and Standards.
F. NEMA LD 3 - High-Pressure Decorative Laminates; National Electrical Manufacturers
Association.
1.04 SUBMITTALS
A. Shop Drawings: indicate materials, component profiles and elevations, assembly methods,
joint details, fastening methods, accessory listings, hardware location and schedule of
finishes.
B. Sustainable Submittals: No submittals are required. Refer to Section 01352 for Sustainable
recommendations on this project. Refer to Section 01352 for recommended VOC limits.
1.05 QUALITY ASSURANCE
A. Perform work in accordance with AWI P-200, Custom quality.
B. Perform cabinet construction in accordance with AWI P-200, Custom quality.
C. Manufacturer Qualifications: Company specializing in manufacturing the products specified in
this section with minimum three years of documented experience.
1.06 DELIVERY, STORAGE, AND PROTECTION
A. Protect units from moisture damage.
1.07 ENVIRONMENTAL REQUIREMENTS
A. During and after installation of work of this section, maintain the same temperature and
humidity conditions in building spaces as will occur after occupancy.
CUSTOM CABINETS 06410 - Page 1 of 3