Specs

Bridgestone Retail Operations, LLC
PROJECT MANUAL
Version: January 2012
c. Greater than 90 inches to 96 inches: 4 anchors.
d. Greater than 96 inches: 4 anchors, plus one for each 24 inches, or fraction thereof, over
96 inches, spaced at 24 inches, maximum, on center.
G. Jamb Anchors for Frames in Stud Partitions: Same material as frame material; minimum 18 gage.
1. Weld anchors inside each jamb for wall anchorage.
2. Provide the following minimum number of anchors, each jamb for indicated frame heights:
a. Up to 60 inches: 3 anchors.
b. Greater than 60 inches to 90 inches: 4 anchors.
c. Greater than 90 inches to 96 inches: 5 anchors.
d. Greater than 96 inches: 5 anchors, plus one for each 24 inches, or fraction thereof, over
96 inches, spaced at 24 inches, maximum, on center.
H. Jamb Anchors for Frames to be Anchored to Previously Placed Concrete, Masonry or Structural
Steel: 3/8 inch diameter bolts with spacers welded to concealed surface of each jamb at:
1. 6 inches from top of frame.
2. 6 inches from bottom of frame.
3. 26 inches, maximum, on center between top and bottom anchors.
I. Glazing Stops: Provide stops to secure glazing for frames specified or scheduled to have glazed
openings; size as indicated on approved shop drawings.
1. Loose Glazing Stops: Removable channel stops of same material as frame material,
minimum 16 gage, butt corners; countersunk for fasteners; secured with Number 6 cadmium
or zinc-plated screws.
2.05 HARDWARE LOCATIONS
A. Hinges:
1. Top: 5 inches from head of frame to top of hinge.
2. Bottom: 10 inches from finished floor to bottom of hinge.
3. Intermediate: Centered between top and bottom hinges.
B. Locks and Latches:
1. Unit and integral type locks and latches: 38 inches from finished floor to centerline of knob.
2. Deadlocks: 48 inches from finished floor to centerline of strike.
C. Door Trim:
1. Door pulls: 42 inches from finished floor to center of grip.
2. Push plates: 48 inches from finished floor to centerline of plate.
PART 3 EXECUTION
3.01 EXAMINATION
A. Prior to installation, check and correct frames for size, swing, squareness, alignment, twist and
plumbness.
3.02 INSTALLATION
A. Install units in accordance with manufacturer's printed installation instructions.
B. Installation Tolerances: Do not exceed the following:
1. Squareness: Plus or minus 1/16 inch measured on a line, 90 degrees from one jamb, at the
upper corner of the frame at the other jamb.
2. Alignment: Plus or minus 1/16 inch measured on jambs on a horizontal line parallel to the
plane of the wall.
3. Twist: Plus or minus 1/16 inch measured at face corners of jambs on parallel lines
perpendicular to the plane of the wall.
4. Plumbness: Plus or minus 1/16 inch measured on the jamb at the floor.
3.03 ADJUSTING
A. Adjust installed doors for correct swings and site tolerances.
END OF SECTION
COMMERCIAL STEEL DOORS AND FRAMES 08112 - Page 3 of 3