Specs

Bridgestone Retail Operations, LLC
PROJECT MANUAL
Version: January 2012
D. Do not allow panels or trim to come into contact with dissimilar materials (i.e. copper,
lead, graphite, treated lumber, mortar, etc.). Water run-off from these materials is also
prohibited.
E. Comply with the SSRS Manufacturer’s approved installation drawings and instructions.
F. Field cutting of panels, trim and/or flashing shall be accomplished by hand or electric
shears. At no time shall a hotsaw be used.
G. Snow Brackets: Install products in strict accordance with manufacturer’s written
instructions and engineered layout charts.. Install with four 2 inch (51 mm) fasteners
directly into sheathing with triangular end of bracket at eave end of shingle and upper
end under shingle in course above.
3.03 ADJUSTING AND CLEANING
A. Repair panels with minor damage.
B. Remove panels damaged beyond repair and replace with new panels to match adjacent
undamaged panels.
C. Clean exposed panel surfaces promptly after installation in accordance with
recommendations of panel and coating manufacturers.
D. Remove protective film immediately after installation.
END OF SECTION
METAL ROOFING SYSTEMS Section 07411 - Page 5 of 5